欢迎光临常州市悦旺热能环保设备有限企业官网!

企业邮箱 收藏六盒宝典资料免费大全收藏六盒宝典资料免费大全 网站地图

悦旺热风炉

常州市悦旺热能环保设备有限企业热风炉开发、研究、设计、生产、安装调一站式服务
热线:139-1232-2077

热门搜索关键词: 生物质热风炉  热风炉改造  热风炉  电加热热风炉  风机  钣金  除尘器  

资讯动态 Classification
联系大家
服务热线:
139-1232-2077

手机:13606115753

传真:0519-8551398

QQ:564546384

地址:常州市戴溪镇西首(戴溪小学向南50米)

当前位置:六盒宝典资料免费大全 > 资讯动态 > 行业动态 > 厂家为您讲解用热风炉时需要注意什么

厂家为您讲解用热风炉时需要注意什么

文章出处:   发布时间:2018-11-17 08:49:31   浏览:20

热风炉不同于普通成都收账实验电炉,其在结构以及使用上都具备特殊性,为了更好成都找人企业保证安全使用,也使其尽可能成都收账发挥果效,有以下收账操作注意:1. 热风炉炉芯位置确定要准确,反应箱必须垂直吊放,高度适中,放置端正,两排箱体之间保持等距,定保炉芯宽度尺寸精确无误.反应箱四角与端墙缝隙处,用纸填实.Hot-blast stove is different from ordinary experimental electric stove. It has special structure and use. In order to ensure its safe use and make it as effective as possible, the following operation should be noted:

1. The position of the hot blast stove core should be determined accurately. The reaction box must be placed vertically, with a moderate height, and placed correctly. The width of the hearth should be kept equidistant between the two rows of boxes. The gap between the corner of the reaction box and the end wall should be filled with paper.
2.开车前检查热风炉成都找人企业轨道有无障碍物,钢丝绳、卷扬机、托轮、小托车必须完好,并按规定加油润滑.
2. Check the track of the hot blast stove before starting. The wire rope, hoist, bracket and trolley must be intact and lubricated according to the regulations.
3.开车人员必须听从装炉操作人员指挥,密切配合.放置炉底乏料,要用钢尺插量三点(两端及中间),按规定尺寸检查,炉头四角的乏料要装足踩实,防止流盐烧墙.
3. Drivers must obey the instructions of furnace loading operators and cooperate closely. Lack of material at the bottom of the furnace should be placed, three points should be inserted with a steel ruler (both ends and the middle), inspected according to the prescribed size, and the material at the four corners of the furnace should be fully stepped on to prevent wall burning by flowing salt.
4.每放完一部炉料后,料斗闭合器要关严密.炉料装完后,洒在端墙拉杆上的乏料或石墨要清理干净,卷扬机小车停放在安全位置,压起顶轴,用盖盖好,并将所装炉号及装炉异常情况填入工艺卡片,随炉传送托车组.
4. The hopper closer should be closed tightly after each charge is put in. After the charge is filled, the waste material or graphite sprinkled on the end wall tie rod should be cleaned up. The winch trolley should be parked in a safe position, the top axle should be pressed up, and the top axle should be covered properly. The furnace number and the abnormal condition of the furnace should be filled into the process card and transmitted to the trolley with the furnace.
5.吊反应箱时,应指挥吊车摆正位置,垂直提升.须待箱体全部拨出后,才能开动热风炉大车吊走.严禁热风炉的炉车在运行中吊反应箱.放反应箱时,按顺序摆放.装炉工应将去掉的四链钩放于箱体之内,以免起钩时挂住外沿使箱体移动位置或箱体碰伤操作人员.
5. When hoisting the reaction box, the crane should be directed to put it in the right position and lift it vertically. The hot blast stove truck can only be hoisted until the box is fully removed. It is strictly forbidden to hoist the reaction box during operation. When placing the reaction box, the reaction box should be placed in sequence. The loader should place the four-chain hook removed in the box so as not to hang the outer edge of the box to make the box move when hoisting the hook. Bruise the operator with a set or a box.

评论

  • 管理员刚刚

    暂无任何留言!

XML 地图 | Sitemap 地图